BMW i8 - The connected vehicle belongs to the model series "i112", treatment is not possible

BMW i8 - The connected vehicle belongs to the model series "i112", treatment is not possible

If you see the following message while working on BMW i8 or i3, here is the fix:

Download the new ISTAP loader with iSeries support, see below:

https://drive.google.com/open?id=1uarr1pS8-1v7ievgaFGmwCL_-bpaHamr


Delete the ISTAP widget you already have on your desktop right now and replace it with this new one from the download link.

 

Click on the EV widget when you are working on that i8.

 


This should support the iSeries BMWs.

 


 


    • Related Articles

    • The vehicle could not be identified successfully. Check vehicle interface and 'PAD active

      A possible bug was identified in ISTAD PRO version 4.22 or later, The bug may cause the connection to the vehicle to fail.   We highly suggest you apply the fix anyway after you install the software.   The fix will take less than 3 minutes:         ...

    • ISTAD - Can't connect to BMW E series

      suggested fix: -Make sure your laptop battery is above %70. -Make sure you BMW battery is fully charged, hooked up to a float charger or the engine is running. Make sure you setup the driver settings as below (after you install it) Control panel à ...

    • ISTAP/ISTAD - Can't connect to BMW F series

      Suggested fix for BMW F series using the certified ENET cable Make sure your laptop battery is above %70. -Make sure you BMW battery is fully charged, hooked up to a float charger or the engine is running. Check your NIC settings and VCI settings, ...

    • Can I change the vehicle order (VO) ? Can ISTA/P recode a new Transmission (TCM)?

      We can’t confirm any kind of fix due several factors like using bad modules or not following the correct procedures.   With that being said, ISTAP is a dealership / workshop grade software, whatever they can do at the authorized BMW dealership, he ...

    • Can't connect to BMW E39

      BMW E39 builds from September 1995  till June 2003 (sedan). For 2001 and older, make sure to use the certified ICOM C to connect to the DME port under the hood, see below: For 2001 and newer , make sure you select EDIABAS under the VCI settings tab ...